Door categorieën bladeren
Ontdekken
Fiverr Pro
Nederlands
$
USD
I will design a usb to uart cp2102n ch340 swdio and swd debugging interface pcb
pcb design
I can help you bring a project to life from scratch, all the way to a fully functional prototype ready for production. I can design a complete board with a microcontroller, power supply circuit, batte...
Over deze dienst
I will design a custom USB-to-UART and SWD debugging interface PCB for embedded systems, microcontroller programming, firmware development, and hardware debugging.
What I can design:
- USB-to-UART converter circuits
- USB-C or Micro-USB connectivity
- CP2102N, CH340, or FTDI-based serial interfaces
- SWD programming and debugging connections
- STM32 and compatible microcontroller interfaces
- TX, RX, SWDIO, SWCLK, GND, and reset connections
- Target voltage reference and logic-level compatibility
- USB ESD protection and power regulation
- Optional boot and reset control circuits
- Compact PCB layouts and connector integration
What you will receive:
- Circuit schematic
- Custom PCB layout
- Bill of materials (BOM)
- Gerber and drill files
- Editable design files according to your package
I consider USB specifications, target voltage, communication requirements, connector types, protection, and debugging compatibility when developing your board.
Please message me before placing an order so we can confirm your microcontroller, programming requirements, and project scope.
Veelgestelde vragen
What does a USB-to-UART interface PCB do?
It allows a computer to communicate with a microcontroller or embedded device through a USB connection converted to serial UART signals.
Can you combine USB-to-UART and SWD on one PCB?
Yes. I can integrate both interfaces into one board, with suitable connectors, signal routing, and power arrangements.
Can you design it for STM32 microcontrollers?
Yes. I can design compatible UART and SWD connections for supported STM32 devices based on their datasheets and pin requirements.
Which USB-to-UART chips can you use?
Depending on the project, options include CP2102N, CH340, and FTDI bridge devices.
Can the board support USB-C?
Yes. I can design a USB-C connection with the appropriate configuration and protection circuitry for the intended USB function.
Can you include target voltage detection and reset control?
Yes. These features can be included where required, subject to the selected debugger architecture and target interface.
Will the board work as a standalone SWD debugger?
A standalone debugger requires a suitable debug-probe controller and compatible firmware. A simple SWD connector only provides access to the target's SWD signals. We should confirm which functionality you need before ordering.
