I will do programming arduino, stm32, microcontrollers

Warmly welcome to my embedded system programming Arduino, stm32, and microcontroller programming gig. I am an Instrumentation and Automation engineer with expertise in embedded systems, electronics, firmware development, IoT, and PCB design.

With this gig, I will help you to gain your requirement by writing professional C programming for stm32 and the Arduino family of microcontrollers and simulating it in STM32 Cube IDE, proteus 8, and Altium. I also provide documentation of the project.

I am best in the following areas:

Microcontrollers: STM32, Atmega

Communication Protocols: USART/UART, I2C, SPI, I2S

Sensors :

1. Temperature
2. Humidity
3. Encoder
4. Current
5. Voltage
6. Ultrasonic
7. Gyroscope/Accelerometer/Magnetometer
8. Gas/Smoke
9. Buttons/Switches
10. PIR Sensor
11. Light Dependent Resistor (LDR)
12. Pressure sensor

Actuators :

1. Buzzer
2. Relay
3. Motor (Stepper, DC motor, Servo, Brushless DC motor)
4. RGB LEDs

I have 4 years of experience writing embedded C code in the stm32 and Arduino microcontrollers family. I am always available for your work. Thank you